POLY TIN REPLACEMENT
SHIELD
For Case 1020 Series
With a May-Wes poly replacement sheet, grain enters the combine at an even and steady rate. Bunching does not cut the horsepower or efficiency of the machine. Expansion seams allow poly to always lie flat. The grain flow never goes against the seam. Bolts are recessed into edging, preventing buildup of residue.
OVER 50% LIGHTER THAN METAL
SHIELD
to reduce wear on combine. 60% less friction than carbon or
stainless steel for smoother flow into combine.
NO ALTERATIONS TO YOUR
COMBINE HEADER
Use the existing hold down tabs and bolts used for metal on the
underside. Use guard bolts on the front side.
COMPLETELY REPLACE EVEN NEW
METAL SHIELD
with Poly Tin Replacement Shield for maximum efficiency of
header. Grain flows over a 1/2 " beveled edge on poly
compared to a 1-3/4 " straight edge wall of metal on
original head set-up. Once the beans are in the header, the 1/4
" edge keeps them from rolling back out.
.gif)
May-Wes poly
lines the floor of the auger where grain enters the combine. Used
in conjunction with May-Wes Poly Tin Replacement, the grain flows
evenly into the combine. Half inch beveled edging of poly lining
eliminates high ridge on factory metal which causes grain to
bunch up.
DURABLE POLY
WON'T RUST. Condensation and wet grain will
not corrode poly lining when the metal is covered with poly. Even
when metal lining is corroded, the poly lining keeps loose grain
from falling through rust holes. Poly lining is much easier to
replace than factory metal. Simply bolt and rivet into place.
 |
 |
| Flex Head | Rigid Head |
For prices on our products please call (306)-586-5711
Email: wilke.sales@sasktel.net